ESP01E Reset & Teardown (FCC ID 2AHMR-ESP01E)

ESP-01/07/12 Series Modules User's Manual OEM/Integrators Installation Manual Version 1.4 Ai-Thinker Inc Copyright (c) 2017 

ESP-01/07/12 Series Modules User's Manual V1.4 
Revision Record Date Version Author Release Notes 2017.07.01 V1.0 Wang Chong First Version 2017.09.04 V1.1 Wang Chong Add ESP-01M, Delete ESP-12E 2017.12.18 V1.2 Fang Dongbin Modify the GPIO4 pin description, change the contact number 2018.3.10 V1.3 Lv Junxiong Add ESP-01F 2018.8.16 V1.4 Lv Junxiong Add ESP-01E 

ESP-01/07/12 Series Modules User's Manual V1.4 
FCC STATEMENT Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Consult the dealer or an experienced radio/TV technician for help. Please notice that if the FCC identification number is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. This exterior label can use wording such as the following: “Contains FCC ID:2AHMR-ESP01M” or “Contains FCC ID:2AHMR-ESP07S”or “Contains FCC ID:2AHMR-ESP12S” or “Contains FCC ID:2AHMR-ESP12F” or “Contains FCC ID:2AHMR-ESP01E”or “Contains FCC ID:2AHMR-ESP01F”any similar wording that expresses the same meaning may be used. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The module is limited to OEM installation ONLY. The OEM in...