WAVEPLUGUS Reset & Teardown (FCC ID 2BDC6-WAVEPLUGUS)

USER AND SAFETY GUIDE
Z-Wave™ smart plug US with power measure
-
ment
READ BEFORE USE
This document contains important technical and safety informa
-
tion about the Device, its safe use and installation.
⚠
CAUTION! 
Before beginning the installation, please read care
-
fully and entirely this guide and any other documents accompany
-
ing the Device. Failure to follow the installation procedures could 
lead to malfunction, danger to your health and life, violation of law 
or refusal of legal and/or commercial guarantee (if any). Shelly 
Europe Ltd. is not responsible for any loss or damage in case of 
incorrect installation or improper operation of this Device due to 
failure of following the user and safety instructions in this guide.
TERMINOLOGY
Gateway 
– A Z-Wave™ gateway, also referred to as a Z-Wave™ 
controller, Z-Wave™ main controller, Z-Wave™ primary controller, 
or Z-Wave™ hub, etc., is a device that serves as a central hub for 
a Z-Wave™ smart home network. The term “
gateway
” is used in 
this document.
S button
 - The Z-Wave™ Service button, which is located on 
Z-Wave™ devices and is used for various functions such as in
-
clusion (adding), exclusion (removing), and resetting the device 
to its factory default settings. The term “
S button
” is used in this 
document.
Device
 – In this document, the term “
Device
” is used to refer to the 
Shelly Qubino device that is a subject of this guide.
ABOUT SHELL Y QUBINO
Shelly Qubino is a line of innovative microprocessor-managed 
devices, which allow remote control of electric circuits with a 
smartphone, tablet, PC, or home automation system. They work 
on Z-Wave™ wireless communication protocol, using a gateway. 
When the gateway is connected to the internet, you can control 
Shelly Qubino devices remotely from anywhere. Shelly Qubino 
devices can be operated in any Z-Wave™ network with other 
Z-Wave™ certified devices from other manufacturers. All mains 
operated nodes within the network will act as repeaters regard
-
less of vendor to increase reliability of the network. Devices are 
designed to work with older generations of Z-Wave™ devices and 
gateways.
ABOUT THE DEVICE
The Device is a smart plug/outlet with power measurement and 
overheating protection, which allows remote control of electric 
appliances with a mobile phone, tablet, PC, or home automation 
system.
INSTALLATION INSTRUCTIONS
The Device can be plugged into standard IEC Type B sockets and 
accepts standard IEC Type B plugs.
⚠
CAUTION!
 Use the Device only with a power grid and appli
-
ances that comply with all applicable regulations. A short circuit 
in the power grid or any appliance connected to the Device may 
damage it.
⚠
CAUTION! 
Do not connect the Device to appliances exceeding 
the given max. load!
⚠
CAUTION!
 Connect the Device only in the way shown in these 
instructions. Any other method could cause damage and/or in
-
jury.
⚠
CAUTION!
 Do not install the Device where it can get wet.
⚠
CAUTION!
 Do not use t...