HUBA Reset & Teardown (FCC ID 2ATIMHUBA)

The device under test is manufactured by the grantee (Sensata Technologies) and sold as an 
Aftermarket product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must 
ensure the end-user has all applicable / appropriate operating instructions. When end-user 
instructions are required, as in the case of this product, the grantee must notify the end-user. 

Sensata Technologies will include the contents of this document in the end user’s manual for 
the commercial product. 

INFORMATION TO BE INCLUDED IN THE END USER'S MANUAL 

The following information (in blue) must be included in the end product user’s manual to 
ensure continued FCC and Industry Canada regulatory compliance. The ID numbers must 
be included in the manual if the device label is not readily accessible to the end user. The 
compliance paragraphs below must be included in the user's manual. 

****************************************************************************** 
FCC ID: 2ATIMHUBA IC: 25094-HUBA 

This device complies with Part 15 of the FCC Rules and with Licence exempt RSS standards of 
Industry Canada. 
Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, and 
(2) This device must accept any interference received, including interference that may cause 
undesired operation. 

Exposure to radio frequency energy. The radiated output power of this device meets the limits of 
FCC/ISED Canada radio frequency exposure limits. This device should be operated with a minimum 
separation distance of 20 cm (8 inches) between the equipment and a person’s body. 

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio 
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: 
(1) l'appareil ne doit pas produire de brouillage, et 
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le 
brouillage est susceptible d'en compromettre le fonctionnement. 

L’exposition à l’énergie radiofréquence. La puissance de sortie rayonné de cet appareil est conforme 
aux limites de la FCC/ISDE Canada limites d’exposition aux fréquences radio. Cet appareil doit être 
utilisé avec une distance minimale de séparation de 20 cm entre l’appareil et le corps d’une personne. 

WARNING: Changes or modifications not expressively approved by the party responsible for 
compliance could void the user's authority to operate the equipment. The term “IC:” before the 
radio certification number only signifies that Industry Canada technical specifications were met. 

******************************************************************************...